log bac2
log sp
Productnaam en omschrijving            

 

Nautix Acralu Aluminium en Metaal EtchPrimer

Etch primer for aluminium and bare metals
 
ACRALU etch-primer is a two-pack paint made to ensure adhesion on aluminium, galvanised steel, zinc, bronze and lead. Only one coat of ACRALU should be applied before overcoating with PE or PA protection primers, fillers and finishing undercoats.
  \"\"  

Verpakkingen:

Pack sizes: 0,5 L - 2 L
Colour: orange

Download Datasheet

Nautix I.A. P.A. Anticorrosie Beschermingssysteem

Long lasting one-pot anticorrosion polyurethane system
formulated with Desmodur® resin, especially recommended for
keel treatment.

NOTE : In all cases, NAUTIX PA should be overcoated (poor resistance to ultra-violet rays). By spray gun application, thinning is necessary.
Put a filter at the exit of paint tank/container.
   \"\"\"\"

Verpakkingen:

Pack sizes: 0,35 L - 0,75 L - 3 L - 21 L
Colour I.A: grey
Colour P.A.: brown red
Download Datasheet

 

 

Nautix P.7

Propeller adhesion primer
   \"\"        

Verpakkingen:

Pack size: spray 300ml
Colour: light grey

Download Datasheet

 

 
 

RECOMMENDATIONS FOR USE OF NAUTIX IA PA CYCLE

 

I – Anticorrosion treatment of cast iron keel and stainless steel hull

 
PREPARATION : Sandblasting, needle scaling or discing to bare metal. Rinse several times with plenty of fresh water. Leave to dry – rust flower appears (orangey colour).
 
APPLICATION : Clean thoroughly all surface with a cloth soaked in NAUTIX D.P. thinner / cleaner. Leave the product to dry through evaporation (30 minutes). Pour out the quantity of paint required in a receptacle and close the can (in order to increase the pot life of the open can). Apply one coat of IA on total surface, avoiding over-thick coat. After 6 to 8 hours (100C), apply a coat of PA. After 6 to 8 hours (100C), apply a second coat of PA. After 6 to 8
hours, if high standard finishing or profiled is desired, apply Nautix epoxy watertight filler. To obtain a uniform background, apply a third coat of PA. After 6 to 8 hours, apply the antifouling.

II – Protection of aluminium (hull, mast, drive leg, propeller)

 
PREPARATION : Wire brushing, grinding, sanding to obtain a bare and dull surface. Rinse wish fresh water
 
APPLICATION : Apply one coat of ACRALU. After 2 to 3 hours (100C), apply a coat of PA. After 6 to 8 hours (100C), apply a second coat of PA. After 6 to 8 hours, apply Nautix epoxy watertight filler if necessary. To obtain an uniform surface, apply a third coat of PA. After 6 to 8 hours, apply antifouling or finishing paint.
 
     
Pacific college medycyny orientalnej http://kupicpigulki.pl/viagra/ GE healthcare karty kredytowej